Harken 1782 System C Battcars: built before 2008 Instrukcja Użytkownika Pobierz pdf (Strona 16)

Installation Troubleshooting

Problem Probable Cause Solution

Cut end of top or bottom track is at joint

Make sure the anodized end is towards the

full length track

Tracks do not butt up against each other

Track weight pulling tracks apart

Tracks will come together when you loosen the bot-

tom screw and push the tracks up the mast

Mounting slugs do not fit Slugs wrong size Different size slug required. Contact your dealer

Mounting screws will not tighten Incorrect mounting slug used Different size slug required. Contact your dealer

Slugs catching on mast splice

Loosen screws slightly. If necessary have someone at

splice area to wiggle the slug past the splice

Corners of cut track catching Use file to round off corners of track

Mast has too much prebend Ease backstay

Track will not slide up mast

Paint or other material clogging mast groove Clean out groove

Headboard coupler does not fit Cars are loaded on mast in the wrong order

Remove cars onto car loaders and load in the

correct order

Track and cars are not the same size Contact your dealer or Harken

Cars do not fit on track

Balls are missing

Remove cars onto car loaders, load balls and slide

cars back on track

Sail headboard does not fit inside coupler Ring was not pressed far enough Take sail to sailmaker

Operation Troubleshooting

Problem Probable Cause Solution

Batten receptacle upside down

Remove nut on batten receptacle post, install so

nut is at the top of the car

Car is on upside down

Remove cars onto car loader and install so barrel

is near the top of the car

Balls missing from car

Remove cars onto car loader, load balls and slide

cars back on track

Cars bind

Dirt in cars

Use detergent and fresh water to flush dirt out of

cars; move cars up/down to circulate; follow with

high pressure water, clean track grooves

Nut on Battcar is not holding Locknut has been used too many times Get new

8" - 18 locknut

Batten receptacle does not rotate Nuts are too tight Loosen nuts slightly

Plastic bushings in Battcar are breaking Washer not used Install washer under nut for vertical post

Cars jam when raising sail Headboard or cars are catching on lazy jacks

Use topping lift or rod vang and shock cord to pull

lack jacks out to shrouds

Sail will not go all the way up Sail is too tall or sheave is too far forward Have sail shortened or move sheave aft

Reef tack fitting will not reach reef hook

Vertical post or pin on batten receptacle bending

Reef point too close to sail attachment

Reef loads are being transferred to batten receptacle

Have sailmaker move reef point or change reef

tack fitting

Transfer reef downhaul and outhaul loads to mast

or boom gooseneck

1251 E. Wisconsin Avenue, Pewaukee, WI 53072

Tel: (262) 691-3320 • Fax: (262) 691-3008 • Website: harken.com • E-mail: [email protected]

Printed in USA 4357/4-00

1 2 ... 11 12 13 14 15 16 17

Komentarze do niniejszej Instrukcji

Brak uwag

Harken 1782 System C Battcars: built before 2008 Instrukcja Użytkownika Strona 16

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Sprzęt komputerowy Harken 1782 System C Battcars: built before 2008